i’ve just updated this older library of mine. i think it brings it to a much higher level.
UPDATES-
* Programs have been moved to a new location inside Nebula- CS9 and CS4 (96khz and 44.1khz sample rates respectively). CS for ‘Cupwise Springs’, and this location is where a some of my other spring reverb libraries are also placed, grouping several similar reverbs together in one spot.
* Removed SHQ versions, they were just dumb. Now there’s just lite and full.
* Some of the impulses were misaligned. Fixed. Probably not too noticeable of a difference.
* Adjusted level of harmonics with the Nolard B full reverb. They were too low.
Most hair transplant procedures can be completed without sedation brand cialis for sale and in under a few hours. So much so, when King Tutankhamen’s tomb was opened in 1922, blue lotuses were found scattered all over his order viagra cheap body.Because of the history related to the flower, blue lotus can be easily found being used as a muse in many paintings, stone carvings and motifs in art and architecture. Researchers questioned each individual, provided unica-web.com cheap levitra them with nerve testing and evaluated their medical backgrounds. Do not consume grapefruit and grapefruit juice may interact with this unica-web.com canadian viagra store product and lead to unwanted side effects.
* Simplified harmonic structures in the reverbs. Allowed me to remove lots of samples and lower CPU. Other excessive samples were removed also.
* Removed the 5 and 9 second options for all programs. Now, lite programs are always cut off at 5 seconds. In some cases you may actually notice the tail being cut off, but in most normal uses it’s pretty quiet after 5 seconds and you won’t be able to tell.
* Lengths of full versions of the programs has been reduced down to 8.5 seconds (from around 9). Lowers CPU use a little and in the vast majority of cases you’d never notice that last half second being missing.
* Added versions with no fade control for the main Raybon and Noldard B reverbs. This drastically lowers CPU and RAM use compared to the programs with the fade control. The Raybon mono mix programs are now only available without the fade control. Check the manual for tips about using the kern page settings to set fade and shorter reverb times in these programs, which is actually more powerful.
* Manual was gone over and a lot of it was re-written, to address any of the above changes and improve some of the wording.
Comments
Trackbacks and pingbacks
No trackback or pingback available for this article.
Leave a Reply to Tim Cancel reply
Featured Products
-
Tube Delay Station
$38.00 -
CupTone vol. 3 – Tone+Distortion
$41.00 -
Plates of Legend vol. 4x
$41.00 -
Plates of Legend vol. 1X
$40.00 -
M-Equalizer
$50.00 -
Assorted HPLP (+High Shelf) Mixing Filters
$22.00 -
Synth HP/LP Filters for Mixing, vol.1
$33.00 -
CupTone vol. 2
$39.00 -
CupReels Ax102
$41.00 -
Cassette 3 – Multi Effects Pack
$39.00 -
Tube Radios Direct, Revamped
$40.00 -
S-609A mk2 Bus Compressor + Limiter
$39.00 -
Tube Radio Reverbs
$29.00 -
C660 mk3 Tube Compressor
$41.00 -
4k Crush
$37.00
I have my original purchased Raybon & Noland Verbs. How do I go about getting theses updates please?
you would have to contact me by email to get customer service, i can’t really help you over this comment section. i need your email address. use the contact form here at my site.